SDS-MAX 16mm

Details;
Application areas;
For drilling in (reinforced) concrete, masonry and natural stone
properties
3-cutting edge carbide geometry
Exactly circular holes, important for dowel fastenings and low-vibration operation for reduced stress on the user
Short transition from carbide tip to drill spiral
Very good removal of drilling dust
3 steep, large-volume turns
Optimal removal of the drilling dust
Counteracts the development of heat in the borehole, lowers the frictional resistance and increases the service life of the drill
150 ° point angle with center point
Provides improved and faster drilling
Wear mark on the hard metal
Produces true-to-size drill holes
Shot-peened surface of the drill body
Reduces wear on the drill flute
One-piece, brazed carbide drill head with a diameter of 16 mm - 28 mm
Ensures a very good and direct energy transfer from the hammer drill to the drill
4-part soldered carbide drill head with diameters of 30 mm - 42 mm
Stresses occurring during drilling can be better absorbed and the load can be better distributed

Processing instructions;
Reinforcement hit: Continue working with reduced pressure. The cutting edge geometry of a rock drill is only suitable for drilling reinforcement to a limited extent.

Working length400 mm
O16 mm
overall length540 mm
PU / ST1